Speaker And Buzzer Volume Adjustments - Ricoh 2400L Operator's Manual

ROUTINE OPERATION
6. Replace the handset.
Do not replace the handset if you wish to speak to the other party again.
When your machine emits a tone, press Stop then speak.

Speaker and Buzzer Volume Adjustments

Your machine has a built in speaker. With this speaker, you can listen to the
telephone line without picking up the handset. The speaker will be automatically
switched off just before the start of facsimile data communication.
When you are sending a fax message, you will be able to hear the line after the
machine has dialed. If the line is busy, you can press the Stop key and start
another operation without having to wait for the machine to disconnect the line.
The volumes you can adjust are:
Transmitting monitor (TRANS MONITOR): The sound you hear in transmission.
Receiving monitor (RECV MONITOR): The sound you hear in reception.
Dialing monitor (DIAL MONITOR): The sound you hear after pressing the Start
key.
Buzzer tone(BUZZER): The volume of the buzzer when you open a cover and so
on.
Key tone (KEY): The sound you hear when you press a key on the operation
panel.
If the speaker volume is not satisfactory, you can adjust it.
1. Function 6 2 2 2 2 9 2 and Yes.
2. Either:
To increase:
To decrease:
To accept: Yes.
3. Repeat step 2 for each adjustment that ap-
pears on the screen.
4. Finish: Function.
k
.
j
.
TELEPHONE CALLS
j k
k k
j k
k k k k
41