Using The Stamp - Ricoh 2400L Operator's Manual

SENDING A FAX MESSAGE

Using the Stamp

Press the Stamp key to achieve the transmission verification stamp.When the
Stamp indicator is lit, the machine stamps a small mark on the bottom of each
page. During memory transmission, the stamp indicates that the page was
successfully stored. For immediate transmission, it shows that the page was sent
successfully. You must switch the stamp on before you press Start , or the
machine will not stamp the first page.
Changing the Stamp Home Position Setting
If you wish to change the Stamp default setting, do the following.
(See page 184 if you need more information about the User Parameter settings
adjustment procedure).
1. Function 6 2 2 2 2 6 3 and Yes.
At this time, you can print a User Pa-
rameter List if you press and Start.
2. Press Yes. The settings for switch 00 are
now shown on the bottom line of the
display. The setting that you need to
change is that for digit 0.
3. If you wish to change the setting, press 0
on the ten key pad.
4. Finish: Yes and Function.
40
ROUTINE OPERATION

!
  



 
Digit 0(Double Underlined)
0: Verification stamp off
1: Verification stamp on