Attaching The Optional Handset; Installing The Optional Feature Expander - Ricoh 2400L Operator's Manual

INSTALLING THE MACHINE

ATTACHING THE OPTIONAL HANDSET

1. Attach the handset stand to the bracket
using the shorter screws. (A)
Then attach the bracket and stand to the
machine using the longer screws. (B)
2. To avoid slack wire hanging at the rear of
the machine, attach the cord clip.
1) Insert the cord into the clip about
two thirds down (see diagram).
2) Peel off the adhesive cover on
the cord clip.
3) Fix the cord clip to the handset
bracket as shown.
3. Plug the cable to 'Tel' jack on rear
side of the machine.
Note: Depending on which handset
you have, install the cord as shown.
INSTAIING THE OPTIONAL FEATURE EXPANDER
Switch off the power before you install the
optional feature expander.
1. Remove the cover on the left side of the
machine.
2. Insert the memory card with the printed
face up.
Make sure that the machine and card
contacts touch.
3. Replace the cover. Then switch on the
power.
34
(A)
(B)