Vertical Comdial DX-80 Technical Manual page 47

DX-80 Programming Manual
2. The system places the cursor in the Source DIR No. field. Key in the CO line directory number you want to
use as a baseline, and press Enter. Valid directory numbers are 740 through 755. There is no default.
3. Once you enter a valid CO line number, the system moves you to the Destination DIR No.field.
4. Enter the CO line directory number you want to copy the baseline's programming into (740-755) and press
Enter. Once you enter a valid CO line number, the system accepts that number and scrolls down a line to
allow you to enter another CO line number into which you want to copy the baseline's programming. Note:
If you enter an invalid number, the system erases your input.
5. In the same manner, enter any other CO line numbers as needed. When you are finished copying the setups,
press Esc. The system then performs the CO line copy that you specified, and returns you to the System
Application — CO Line Copy Individual menu.
6. If needed, you can enter another source CO line directory number to copy from, and continue the process
for other CO lines.
7. When you are done, press Esc to return to the Database Programming screen. The system prompts: "Exit
This Feature?"; press Y for yes.
8. The system prompts "Save Current Setting?" Press Y to save your changes.
9. The system then prompts "File Exists, Override?" Press Y to continue with the save operation.
10. Press Esc to return to the Database Programming menu.
11. When you have finished all programming changes, perform a Send operation to copy your new database to
the DX-80 switch system memory. For more details, see Section 2.1.4.4, F4 – Send.
To copy a CO line setup to all the lines in a line group, perform the following steps.
1. Highlight Group and press Enter. The system displays the System Application — CO Line Copy Group
menu.
G S > S
ETTING TARTED HORTCUTS TO
- 47 -
H Y W F
ELP OU ORK ASTER