Vertical Comdial DX-80 Technical Manual page 236

P V M
ROGRAMMING OICE AIL
5. Press the Hold button to return to the previous menu level,
Or,
Press the Volume button (up or down) to return to the DB Item Selection screen.
Next, program the VM Table – Prefix Table – Transfer.
1. Enter 06-02-1~3-02-02, where 1~3 = tenant group.
2. Press save, then press chg. Enter the prefix numbers you want the system to use to identify a call as trans-
ferred to mailbox. Then press save.
3. Press next to continue programming the various call handling digits (prefix/suffix).
4. Press the Hold button to return to the previous menu level,
Or,
Press the Volume button (up or down) to return to the DB Item Selection screen.
Next, program the VM Table – Prefix Table – Busy FWD.
1. Next, enter 06-02-1~3-02-02, where 1~3 = tenant group.
2. Press save, then press chg. Enter the prefix numbers you want the system to use to identify a call as for-
warded from a busy mailbox. Then press save.
3. Press next to continue programming the various call handling digits (prefix/suffix).
4. Press the Hold button to return to the previous menu level,
Or,
Press the Volume button (up or down) to return to the DB Item Selection screen.
Next, program VM Table – Prefix Table – No Answer.
1. Enter 06-02-1~3-02-02, where 1~3 = Tenant Group.
2. Press save, then press chg. Enter the prefix numbers you want the system to use to identify a call when for-
warded from a mailbox-no answer. Then press save.
3. Press next to continue programming the various call handling digits (prefix/suffix).
4. Press the Hold button to return to the previous menu level,
Or,
Press the Volume button (up or down) to return to the DB Item Selection screen.
Next, program the VM Table – Prefix Table – Direct.
1. Enter 06-02-1~3-02-02, where 1~3 = tenant group.
2. Press save, then press chg. Enter the prefix numbers you want the system to use to identify a call as imme-
diately from this mailbox owner. Then press save.
3. Press next to continue programming the various call handling digits (prefix/suffix).
4. Press the Hold button to return to the previous menu level,
Or,
Press the Volume button (up or down) to return to the DB Item Selection screen.
Next, program VM Table – Prefix Table – CO greeting.
> P T P
ROGRAMMING HIRD
VM, A P
ARTY NALOG ORTS
- 236 -
DX-80 Programming Manual