Installing Mil/Activemil - Matrox 4Sight User Manual

Reassigning the hard
disk to C:\
disk/drive containing the paging file (C:\ by default), and
provided that no applications are currently running from
the disk/drive selected.
If necessary, you can reset your hard disk to C:\ in a two-step
process. First, repeat steps 1 through 5 above for the disk that
is currently assigned to C:\. Then, once that disk is reassigned,
assign the hard disk to C:\.

Installing MIL/ActiveMIL

Prior to installing MIL or ActiveMIL you must install the
Microsoft development platform MSDEV. Refer to the
appropriate installation manual for installation instructions.
In addition to your MIL CD, you will require a hardware key
(a two-sided, 25 pin connector) if you plan to use the Matrox
4Sight as a development PC for MIL applications. The key
allows you to code, debug, and run your applications. Note that
Intellicam, your digitizer configuration program, is installed
with MIL; however, Matrox Intellicam will not work with an
embedded operating system.
To install your MIL software:
1. Attach the hardware key to the parallel port of your
computer. If another device such as a printer is attached to
the parallel port, turn it off and disconnect it from the
parallel port. Then, attach the hardware key to the parallel
port, and connect the device to the other end of the hardware
key. The presence of the hardware key will not cause any
communication interference with your device.
2. Place the installation CD in an appropriate drive. The
setup.exe program will run automatically.
During installation, you will be asked a number of questions,
such as:
The drive and directory on which to install the program.
Your target operating system and compiler.
The type of Matrox hardware installed in your computer (for
example, Matrox Meteor-II).
Installing MIL/ActiveMIL 83