Installing A Full Windows Nt Workstation On Matrox 4Sight; Installing Device Drivers - Matrox 4Sight User Manual

78 Chapter 6: Using the hard drive based Matrox 4Sight
After connecting an IDE hard drive or CD-ROM drive, you must
notify Matrox 4Sight of this change in configuration, using the
BIOS Setup program. The BIOS is accessed by pressing the
Delete key during the boot procedure.
Also available for connecting additional IDE devices is an ATA
connector (indicated in diagram) which allows the connection
of an additional two ATA compliant devices, such as hard
drives. If you need to connect two devices to this connector, you
will have to connect them in a master/slave configuration and
use a 44-pin flat ribbon cable that has three connectors.
Installing a full Windows NT Workstation on
Matrox 4Sight
To install a full Windows NT Workstation on the Matrox 4Sight
hard disk, you must install a CD drive and external floppy drive
on your Matrox 4Sight unit. Then, refer to the Windows NT
installation manual to install it.

Installing device drivers

When installing a full Windows NT Workstation, you need to
install custom device drivers located on the Matrox 4Sight CD.
This section describes how to install each of these drivers.
Geode display driver
To install the Geode display driver:
1. From the Control Panel, click on the Display icon. The
Display Properties dialog box is presented.
2. Select the Setting property page and click on the Display
type button.
3. Then, click on the Change button. A dialog box allowing
you to change the current display driver is presented.