Drive Assignment Section - Matrox 4Sight User Manual

order). If you subsequently install a hard drive, again you
should change the appropriate fields in the CMOS setup of
the BIOS.

DRIVE ASSIGNMENT section

Drive A:
This field specifies the size/capacity of the floppy drive.
Options:
None (default)
360 KB, 5.25"
1.2 MB, 5.25"
720 KB, 3.5"
1.44 MB, 3.5"
2.88 MB, 3.5"
Drive 1, Drive 2, and Drive 3:
These fields map the installed hard drives to drive numbers.
The drive numbers are associated with drive letters
according to the boot sequence specified in the Boot Order
Sequence section. Note that by default the drive numbers
correspond to the DOS operating system's drive letter
assignments in alphabetic order. Options:
None (You can purchase Matrox 4Sight without a hard
drive).
IDE Master
IDE Slave
ATA Master
ATA Slave
By default, Drive 1 is set to ATA Master while the
remaining drive numbers are not assigned since there is
usually only one factory-installed hard drive on Matrox
4Sight (if any). Only enabled drives (drives from the Drive
Selection section that are enabled) are allowed. Note that if
no hard drive is present, but the drive is enabled in the BIOS,
no error is generated (Matrox 4Sight will boot from the
Basic CMOS Configuration subscreen 153