Connecting An Alternate Hard Drive; Connecting To A Flat Panel; Installing A Pc/104-Plus ™ Board - Matrox 4Sight User Manual

Connecting an alternate hard drive

If you wish to connect an external hard drive, refer to Chapter
6: Using the hard drive based Matrox 4Sight.

Connecting to a flat panel

Matrox 4Sight supports connection to any flat panel that
complies with the VESA FPDI-1 specifications.
To interface a flat panel to Matrox 4Sight:
Attach a 41-pin flat ribbon cable to the interface connectors
on your Matrox 4Sight and flat panel.
Attach a power cable from the flat panel backlight connector
on Matrox 4Sight to the backlight power supply connector on
your flat panel.
Installing a PC/104-Plus
You can install up to three PC/104-Plus
Matrox 4Sight motherboard in a stackthrough configuration,
as shown below. Each board must be attached to the other
through four jack screws.
module 3
module 2
module 1
TM
PC/104- Plus
(PCI) connector
™
board
Matrox 4Sight motherboard
Additions to the unit
™
boards on the
PC/104-
board
PC/104-
board
PC/104-
board
PC/104
(ISA) connector
87
Plus TM
TM
Plus
Plus TM
TM