Matrox 4Sight User Manual page 149

Note, once the BIOS has been upgraded, you can use the Basic
CMOS Configuration subscreen to reset the time and date on
the Matrox 4Sight unit as described below. Alternatively, while
operating under Embedded-DOS, you can set the time and date
as follows:
1. Open a command prompt window.
2. Type time after the C:\...> prompt and press Enter.
3. The unit will respond with the current time in memory and
prompt you to enter the new time.
4. If the current time is correct, press Enter.
5. To change the time, enter it using the hour:minute 24-hour
format.
To change the calendar date:
1. Open a command prompt window.
2. Type date at the C:\...> prompt and press Enter.
3. The unit will respond with the current date in memory and
prompt you to enter the new date.
4. If the current date is correct, press Enter.
5. To change the date, enter it using the month-date-year
calendar format.
Upgrading the BIOS of the Matrox 4Sight 149