Installing An Ethernet Driver - Matrox 4Sight User Manual

80 Chapter 6: Using the hard drive based Matrox 4Sight
3. Click on the Add button and select the Unlisted or
Updated Driver entry.
4. Click on the Ok button to access the browse dialog. Press
the Browse button to specify the path of the Geode sound
driver files; they are located in the
DRIVERS\WINNT\SOUND directory of the
Matrox 4Sight CD.
5. Select the XpressAudio Driver entry in the presented list
box and click on Ok to start the installation of the driver.
6. Leave the suggested I/O address, and press the Continue
button when prompted for the XpressAudio Base I/O
address. The XpressAudio Configuration dialog box is
presented.
7. Select Disable as the MPU401 I/O Address and click Ok to
end the installation.
8. You must reboot the unit to use the new driver.

Installing an Ethernet driver

In order to install the proper Ethernet driver on Windows NT
Workstation, you must first detect the type of Ethernet
controller that your Matrox 4Sight has. This detection must be
done manually using a command prompt window, and a utility
provided on the Matrox 4Sight CD. The detection steps are as
follows:
1. Ensure that Windows NT Workstation has been installed
without any network components.
2. Open a command prompt window.
3. Copy all the files (WHICHNET.BAT, DUMPPCI.EXE, and
PCIDUMPR.SYS) from the \Drivers\winnt\network
directory on the Matrox 4Sight CD to the C:\ drive.
4. Go to the C:\ command prompt window and type
'WHICHNET'.
The utility will report either that a DAVICOM Ethernet
controller or an INTEL Ethernet controller is present. If a
DAVICOM Ethernet controller is present, you should follow
the 'Matrox Ethernet driver' installation procedure.