Matrox 4Sight User Manual page 38

38 Chapter 2: Connecting and configuring external peripherals to the unit
that comes pre-installed as the first PC/104-Plus board in
Matrox 4Sight, has been modified slightly. If you initially
purchase your Matrox 4Sight without a Matrox Meteor-II board
and then need to add one later, this point will be crucial in
ordering the appropriate Matrox Meteor-II board. The pin outs
for this connector are detailed in Appendix D.
Connect your camera to the external input connector of a
Matrox Meteor II/Standard on the Matrox 4Sight unit using
the optional DBHD44-to-13BNC cable as follows:
DBHD44-to-13BNC cable
Wires Signals
Red VID_IN1
Green VID_IN2
Blue VID_IN3
Black VID_IN4
Gray OPTOTRIG External trigger input
White VID_IN5
Yellow VID_IN6
Purple VID_IN7
Brown VID_IN8
Light blue VID_IN9
Orange VID_IN10
Pink VID_IN11
Light green VID_IN12
Note that you can also connect to the external input connector
of the Matrox Meteor-II/Standard on the Matrox 4Sight unit
using the DBHD44-to-8BNC cable. In this case, use the color
coding of the wires described in the first eight rows of the above
table.
Expected Input
Analog Video Input1 or Y1
Analog Video Input2 or C1
Analog Video Input3 or Y2
Analog Video Input4 or C2
Analog Video Input5 or C4
Analog Video Input6 or Y3
Analog Video Input7 or C3
Analog Video Input8 or Y4
Analog Video Input9 or Y5
Analog Video Input10 or C5
Analog Video Input11or Y6
Analog Video Input12 or C6