Installing A Mil Application - Matrox 4Sight User Manual

Installing a MIL application

To install a MIL application on Matrox 4Sight, you must copy
the application's files to the Matrox 4Sight unit. To do so:
1. On the Matrox 4Sight unit, share the target directory. For
instructions on sharing directories see
Chapter 3: Managing the Matrox 4Sight under Windows NT
Embedded.
2. On your development computer, connect and map a logical
drive to this shared directory.
3. On your development computer, switch to the logical drive
mapped to the target Matrox 4Sight directory. Change the
current directory to the sub-directory in which you want
your application to reside.
4. Copy the MIL application files from the development
computer to the Matrox 4Sight unit. Make sure to copy the
application's EXE file, applicable DLL files, and DCF files
(if used).
5. The version of the MIL DLL files that come pre-installed on
the DiskOnChip are sufficient to run a MIL-Lite application.
If your application uses a MIL image processing module,
you must copy this module's files from the Matrox 4Sight
CD to the Matrox 4Sight unit. To copy these files, place the
Matrox 4Sight CD in the CD drive of your development
computer, share this drive, and from the Matrox 4Sight
unit, connect and map a logical drive to this CD drive
(discussed earlier).
6. For a MIL application, you should provide a MIL run-time
license to run the application. Refer to the MIL User Guide
for more information.
To demonstrate the above concepts, the following leads you
through the installation of the example application, Mfocus.exe,
on a Matrox 4Sight unit. We will make the following
assumptions regarding:
Installing a MIL application 55