Input Channels; Low-Pass Filter; Gain - Matrox 4Sight User Manual

Performance
Matrox Meteor-II /Multi-Channel grab section
The video timing parameters (including those for progressive
scan) supported by the Matrox Meteor-II /Multi-Channel board
are as follows:
Number of pixels / line (including sync and blanking) 4096*
Number of lines / frame (including sync and blanking) 4096*
Sampling rate (with external clock input, or in
line-locking mode)
*Note that the maximum number of pixels per line that MIL
supports is:

Input channels

The Matrox Meteor-II /Multi-Channel frame grabber can
switch between two RGB or six monochrome video sources. You
can use the MIL-Lite MdigChannel() command to switch
between video sources (or channels).

Low-pass filter

The input low-pass filtering stage is used to limit high
frequency noise and aliasing effects at the input of the triple
A/D converter. The filter used on Matrox Meteor-II
/Multi-Channel is a 4th order Butterworth filter with a cutoff
frequency of 10 MHz.

Gain

Matrox Meteor-II /Multi-Channel has adjustable gains. This
allows you to optimize the video input signal range.
Pixels
------------- - x Number of Lines
Line
Max
30 MSPS
≤
4 Mbytes
117