Specifying Sip Settings - Polycom VSX 3000 Administrator's Manual

Specifying SIP Settings

If your network supports the Session Initiation Protocol (SIP), you can use SIP
to connect IP calls.
To specify SIP Settings:
1. Go to System > Admin Settings > Network > IP > SIP Settings.
2. Configure these settings on the SIP Settings screen:
Setting Description
Transport Indicates the protocol the system uses for SIP signaling.
Protocol
The SIP network infrastructure in which your VSX system is
operating determines which protocol is required. For example, if
your VSX system is operating in a Microsoft® Live
Communication Server (LCS) SIP network, choose TCP. If your
VSX system is operating in a Nortel Multimedia Communication
Server (MCS) SIP network, choose UDP.
Authentication Specifies the name to use for authentication when registering
Name with a SIP Registrar Server. If you leave this field blank, the User
Name is used for authentication.
User Name Specifies the system's SIP name. If you leave this field blank, the
system's IP address is the SIP user name.
Password Specifies the password that authenticates the system to the
Registrar Server.
Registrar Specifies the DNS name or IP address of the SIP Registrar
Server Server.
By default, the SIP signaling is sent to port 5060 on the registrar
server. To specify a different port, add it to the address as shown
here:
10.11.12.13:5070
Proxy Server Specifies the DNS name or IP address of the SIP Proxy Server. If
you leave this field blank, no proxy server is used.
By default, the SIP signaling is sent to port 5060 on the proxy
server. To specify a different port, add it to the address as shown
here:
10.11.12.13:5070
Networks
2 - 9