Polycom VSX 3000 Administrator's Manual page 151

Symptom
Cannot access the system
remotely.
Cannot manage the system
remotely.
Cannot connect to the
Directory Server.
Problem
The system does not allow
remote access.
The system or your
computer is not connected
to the LAN.
The LAN cable to the
system or to your computer
is bad.
To verify this, check the
lights on the system. There
should be a steady green
light indicating a connection
to the LAN, and a flashing
orange light indicating LAN
traffic if the cable is good.
DHCP Client is ON and no
DHCP server is available.
There is a firewall between
your computer and your
system.
Your computer is on a
different network and there
is not connectivity between
the networks.
The system requires that
you provide new passwords
when switching into
Security Mode.
The system is in Security
Mode, which requires
secure access.
You have not entered the
correct password.
Too many managers are
logged into the system.
The system does not
automatically reconnect to
the Directory Server when a
network cable is unplugged
and reconnected.
Corrective action
On the system, go to Admin Settings > General
Settings > Security >
Check the LAN cable to the LAN port on the rear of
the system.
Check the LAN cable to your computer.
Replace the appropriate LAN cable.
Contact your network administrator.
Contact your network administrator.
Place your computer and system on the same
subnet. If this corrects the problem, check your router
configuration. If it does not, contact your network
service provider.
Enter a new password when prompted by the
system.
Use secure modes of Telnet, FTP, Web, and serial
access. For more information, refer to
Security Mode on page 8-6.
Enter the correct user name and remote access
password.
Note: For web access, the user name is admin, and
the default password is the unit's serial number.
Only five system managers are allowed at any one
time. To log everyone out, restart your system.
Recheck Register on the Global Directory Servers
screen (System > Admin Settings > Global
Services > Directory Servers) to manually
reconnect to the Directory Server.
Troubleshooting
and enable access.
Configuring
12 - 7