Monitoring A Room Or Call With The System's Web Interface - Polycom VSX 3000 Administrator's Manual

Administrator's Guide for the VSX Series

Monitoring a Room or Call with the System's Web Interface

9 - 2
To access the system using the system's web interface:
1. On a computer, open a web browser.
2. In the browser address line, enter the system's IP address, for example,
http://10.11.12.13, to go to the system's web interface.
If Security Mode is enabled on the system, you must use secure HTTPS
access, for example, https://10.11.12.13. Click Yes in the security
dialog boxes that appear.
3. If prompted, enter admin as the user name, and enter the remote access
password.
You can use the system's web interface to configure all of the system settings
except the remote management settings. For security reasons, these settings
must be configured on the local system by an administrator.
The monitoring feature within the system's web interface allows
administrators of VSX systems to view a call or the room where the system is
installed. For security reasons, this feature can only be enabled on the local
system by an administrator.
To enable room and call monitoring:
1. Go to System > Admin Settings > General Settings > Security.
2. Select and enable Allow Video Display on Web to allow the room
or call to be viewed remotely.
To view a room or call:
1. On a computer, open a web browser.
2. In the browser address line, enter the system's IP address, for example,
http://10.11.12.13, to go to the system's web interface.
3. Go to Utilities > Web Director.
4. Perform any of the following tasks:
— Place or end a call
— View near and far sites
— Change camera sources
— Adjust camera position
— Zoom cameras
— Adjust system volume settings
— Mute and unmute the microphones
You can view near and far sites without opening Web Director by selecting
Tools > Remote Monitoring.