How To Shift A Mobile X-Ray Unit - Smiths detection HI-SCAN 5170-A User Manual

How to start and terminate your work
A
Warning!
The supply cable should not be pulled over sharp edges! Keep the cable dry and protect it against
heat, oil and grease!
A
Caution!
Lay the mains cable in such a way that people do not step on or trip over cables!
 Having successfully checked the latter, plug in the mains
cable at the unit and the appropriate mains outlet.
If a separate earth clamp* exists on the unit, make sure
an earthing wire is connected to the clamp.
A
Warning!
Operation without protective earthing is not
permitted! If necessary have the protective
earthing installed by a technician!

How to shift a mobile X-ray unit*

S
Attention!
You may move the X-ray unit to another installation site only if it is installed on a mobile base de-
livered by Smiths Heimann!
S
Attention!
When changing the installation site, it is imperative that the legal and official regulations are com-
plied with (F 1-3)!
 Adhere to the instructions of the preceding paragraph, then withdraw the mains cable from the socket
and from the unit.
 Use the enclosed wrench to turn all adjusting feet
completely upward.
 Carefully shift the X-ray unit to the new place of in-
stallation. Be aware of ground unevenness.
S
Attention!
In any case avoid heavy vibrations!
1-30
610
640
590
600
620
630
95587412 01/01/09 © Smiths Heimann