Smiths detection HI-SCAN 5170-A User Manual page 127

 If no drive was plugged in yet, loosen the two illus-
trated screws and remove the lid to the right.
 If a drive or an empty plug-in unit already exists, move
the illustrated lever to the right and pull out the drive
or the empty plug-in unit.
 Move in the new drive until the release trigger locks.
 Switch on the X-ray unit afterwards.
I
After switching on, the indicator of the drives
lights up shortly. This indicates that the drive
has been installed correctly.
Peculiarities of older RIDA removable drives*
 Insert the appropriate key into the lock on the right
side of the drive and slightly press it in, then turn it to
the right into a vertical position.
 You can now withdraw the hard disk with its handle
and insert the new one.
 Finally, press in the key slightly again and turn it to the
left into the horizontal position. Withdraw the key.
95587413 01/01/09 © Smiths Heimann
How to use the ZIP*, RIDA* and CD/DVD* drive and the USB interface*
2-5