F161
OUT2 Off Delay
Program
Terminal Selection Parameters
⇒
⇒
OUT2
This parameter delays the opening of the OUT2 (A & C) output terminals by
the programmed value (see waveforms at F160).
The delay may be increased to allow the devices that are connected to OUT2 to
respond.
FL Off Delay
Program
⇒
Terminal Selection Parameters
FL
⇒
This parameter delays the opening of the FL output terminals by the
programmed value (see waveforms at F160).
The delay may be increased to allow the devices that are connected to FL to
respond.
OUT4 Off Delay
Program
⇒
Terminal Selection Parameters
⇒
OUT4
This parameter delays the opening of the OUT4 output terminals by the
programmed value (see waveforms at F160).
The delay may be increased to allow the devices that are connected to OUT4 to
respond.
OUT5 Off Delay
Program
Terminal Selection Parameters
⇒
OUT5
⇒
This parameter delays the opening of the OUT5 output terminals by the
programmed value (see waveforms at F160).
The delay may be increased to allow the devices that are connected to OUT5 to
respond.
OUT6 Off Delay
Program
⇒
Terminal Selection Parameters
⇒
OUT6
This parameter delays the opening of the OUT6 output terminals by the
programmed value (see waveforms at F160).
The delay may be increased to allow the devices that are connected to OUT6 to
respond.
76
Output Terminal Delays
⇒
⇒
Output Terminal Delays
⇒
Output Terminal Delays
Output Terminal Delays
⇒
⇒
Output Terminal Delays
Direct Access Number — F161
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Direct Access Number — F162
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Direct Access Number — F163
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Direct Access Number — F164
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Direct Access Number — F165
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
H7 ASD Operation Manual
F165