Toshiba H7 Operation Manuals page 40

PG Position — Displays the Pulse Generator Position.
RR — Displays the RR input value as a percentage of the full range of the RR value (potentiometer
input).
*VI/II — Displays the VI input setting as a percentage of the full range of the VI/II value.
Note: * The VI/II input represents two analog inputs (and terminals). The VI input
terminal is primarily used for a 0 – 10 VDC analog signal and the II input
terminal is used for current loop applications, such as with a 4-20 mA signal.
Either may be used as a frequency or torque command source; however, the two
cannot function simultaneously. Throughout this manual they will be listed as
VI/II.
RX — Displays the RX input setting as a percentage of the full range of the RX value (-10 to
+10 VDC input).
RX2 — Displays the RX2 input setting as a percentage of the full range of the RX2 value.
Note: The RX2 function is available on the ASD-Multicom option board only.
FM — Displays the output frequency value as a percentage of the full range of the FM value.
AM — Displays the output current as a percentage of the full range of the AM value.
Option Type — Displays the type form number of the installed ASD-Multicom option board.
Option Term A — TBD.
Option Term B — TBD.
Option Term O — TBD.
Option Term P — TBD.
Max. Output — TBD.
Fault Status — Displays the current fault or No Fault.
H7 ASD Operation Manual 33