Eoi Operation - Toshiba H7 Operation Manuals

Rotary Encoder — Functions as the Up key, the Down key, and the Enter key. Turn the Rotary
Encoder either clockwise or counterclockwise to perform the Up or Down key functions. Press the
Rotary Encoder to perform the Enter function. Simultaneously pressing and turning the Rotary
Encoder performs a user-defined function (see Program
Encoder Action).
MON/PRG — Provides a means to access the three root menus. Pressing the MON/PRG key repeatedly
loops the system through the three root menus (see
menus, the Program menu will display the last menu screen or sub-menu item being accessed at the time
that the MON/PRG key was pressed.
Figure 18. The H7 Electronic Operator Interface.
Local/Remote
Key (LED)
Monitor/Program
Key
Run Key
(LED)

EOI Operation

The EOI is the primary input/output device for the user. The EOI may be used to monitor system
functions, input data into the system, or perform diagnostics.
Note: The Up/Down arrow keys and the Enter key may be used to perform the functions of the
Rotary Encoder. The Rotary Encoder will be used in this explanation and throughout
this manual for the Up, Down, and Enter key functions.
The software used with the H7 is menu driven; thus, making it a select and click environment. The
operating parameters of a motor may be selected and viewed or changed using the EOI.
To change a parameter setting, go to the Program mode by pressing the MON/PRG key until the
Program menu is displayed. Turn the Rotary Encoder until the desired parameter group is within the
cursor block. Press the Rotary Encoder (repeat if there is a submenu).
The selection will take on the reverse video format (dark background/light text). Turn the Rotary
Encoder to change the value of the parameter. Press the Esc key while the display is in the reverse video
mode to exit the menu without saving the change or press the Rotary Encoder to accept the new setting.
Repeated Esc key entries takes the menu back one level each time the Esc key is pressed until the root
level is reached. After reaching the root level, continued Esc entries will toggle the system to and from
the Frequency Command screen and the Panel menu.
Note: Panel menu changes made in this way will affect EOI-controlled ASD operation only.
LED Keypad-controlled functions will not be affected. LED Keypad-controlled
operation settings may be viewed or changed at F008.
24
⇒ EOI Option Setup ⇒
Figure 21 on pg. 30). While looping through the root
LCD Display
Enter Key
Up/Down Arrow
Keys
Rotary Encoder
Esc Key
|
Stop
Preferences ⇒ Pressed
Reset Key
H7 ASD Operation Manual