Toshiba H7 Operation Manuals page 64

Adjustable speed drive
Hide thumbs Also See for H7:
Table of Contents

Advertisement

F023
Preset Speed #6
Program
Pattern Run Control
This parameter assigns an output frequency to binary number 0110 and is
identified as Preset Speed #6. The binary number is applied to S1 – S4 of the
Control Terminal Strip to output the Preset Speed (see
information on this parameter).
Preset Speed #7
Program
Pattern Run Control
This parameter assigns an output frequency to binary number 0111 and is
identified as Preset Speed #7. The binary number is applied to S1 – S4 of the
Control Terminal Strip to output the Preset Speed (see
information on this parameter).
Low Speed Signal Output Frequency
Program
Terminal Selection Parameters
The Low Speed Signal Output Frequency parameter sets a frequency
threshold that activates the assigned output terminal so long as the ASD output
is at or below this setting (see
assignments).
Speed Reach Frequency
Program
Terminal Selection Parameters
The Speed Reach Frequency sets a frequency threshold that, when reached or
is within the bandwidth specified by parameter F102, will provide a signal at an
output terminal that can close an appropriately configured output contact (see
Table 7 on pg. 72
for the available output assignments).
H7 ASD Operation Manual
Preset Speeds
6
F018
Preset Speeds
7
F018
Reach Settings
Table 7 on pg. 72
for the available output
Reach Settings
Direct Access Number — F023
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
for further
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Direct Access Number — F024
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
for further
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Direct Access Number — F100
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — 0.0
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F101
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — 0.0
Maximum — Max. Freq. (F011)
Units — Hz
F101
57

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents