Toshiba H7 Operation Manuals page 136

F441
Driving Torque Limit #1
Program Torque Setting Parameters
⇒
Settings
This parameter provides a value for the Power Running Torque Limit #1
setting if Setting is selected at F440. This value provides the positive torque
upper limit for the #1 motor.
Regeneration Torque Limit #1
Program ⇒ Torque Setting Parameters
This parameter determines the source of the Regenerative Torque Limit
control signal. If Setting is selected, the value set at
parameter.
Settings:
VI/II
RR
RX
RX2 (option)
Setting
Regeneration Torque Limit Setting #1
Program Torque Setting Parameters
⇒
Manual Settings
This parameter provides a value to be used as the Regeneration Torque Limit
#1 if Setting is selected at F442.
Driving Torque Limit #2
Program ⇒ Torque Setting Parameters
Settings
This parameter is used to set the positive torque upper limit for the #2 motor
profile when multiple motors are controlled by a single drive or when a single
motor is to be controlled by multiple profiles.
H7 ASD Operation Manual
Manual Torque Limit
⇒
⇒ Torque Limit Settings
F443 is used for this
Torque Limit Settings
⇒ ⇒
⇒ Manual Torque Limit
Direct Access Number — F441
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.0
Units — %
Direct Access Number — F442
Parameter Type — Selection List
Factory Default — Setting
Changeable During Run — Yes
Direct Access Number — F443
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.0
Units — %
Direct Access Number — F444
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.0
Units — %
F444
129