Toshiba H7 Operation Manuals page 127

F377
Speed Loop Integral Gain
Program Feedback Parameters
⇒
This parameter sets the response time of the Speed Loop Integral Gain. The
smaller the value here, the more pronounced (quicker) the effect of the integral
function.
Motor Counter Data
Program ⇒ Feedback Parameters
Contact Toshiba's Marketing Department for information on this parameter.
Speed Loop Parameter Ratio
Program ⇒ Feedback Parameters
Contact Toshiba's Marketing Department for information on this parameter.
Use Speed Mode
Program Pattern Run Control Parameters
⇒
This parameter Enables/Disables the Use Speed mode. When enabled, the
system uses all of the parameter settings of the Preset Speed being run.
Otherwise, only the frequency setting is used.
Preset Speed Direction #1
Program ⇒ Pattern Run Control Parameters
Determines the forward/reverse setting for the #1 Preset Speed (F018).
Preset Speed Direction #2
Program ⇒ Pattern Run Control Parameters
Determines the forward/reverse setting for the #2 Preset Speed (F019).
120
PG Settings
⇒
⇒ PG Settings
⇒ PG Settings
Preset Speed Mode
⇒
⇒ Preset Speeds
⇒ Preset Speeds
Direct Access Number — F377
Parameter Type — Numerical
Factory Default — (drive dependent)
Changeable During Run — Yes
Minimum — 10.0
Maximum — 200.0
Direct Access Number — F378
Parameter Type — Selection List
Factory Default — Selection 0
Changeable During Run — No
Minimum — Selection 0
Maximum — Selection 5
Direct Access Number — F379
Parameter Type — Numerical
Factory Default — 1.00
Changeable During Run — No
Minimum — 0.01
Maximum — 10.00
Direct Access Number — F380
Parameter Type — Check Box
Factory Default — Disabled
Changeable During Run — No
Direct Access Number — F381
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Direct Access Number — F382
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
H7 ASD Operation Manual
F382