Toshiba H7 Operation Manuals page 71

F119
S5 Input Terminal Assignment
Program Terminal Selection Parameters
⇒
Assignment ⇒ S5
This parameter selects the functionality of the S5 input terminal.
Note: The S5 input terminal may be used without the ASD-Multicom option
board.
Without the ASD-Multicom option board the S5 terminal assignment
information will be stored in volatile memory. The terminal assignment
information will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S5 terminal to 1 of the 68 possible
functions that are listed in Table 6 on pg.
S6 Input Terminal Assignment
Program ⇒ Terminal Selection Parameters
Assignment ⇒ S6
This parameter selects the functionality of the S6 input terminal.
Note: The S6 input terminal may be used without the ASD-Multicom option
board.
Without the ASD-Multicom option board the S6 terminal assignment
information will be stored in volatile memory. The terminal assignment
information will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S6 terminal to 1 of the 68 possible
functions that are listed in Table 6 on pg.
S7 Input Terminal Assignment
Program Terminal Selection Parameters
⇒
Assignment S7
⇒
This parameter selects the functionality of the S7 input terminal.
Note: The S7 input terminal may be used without the ASD-Multicom option
board.
Without the ASD-Multicom option board the S7 terminal assignment
information will be stored in volatile memory. The terminal assignment
information will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S7 terminal to 1 of the 68 possible
functions that are listed in Table 6 on pg.
64
Input Terminal
⇒
67.
⇒ Input Terminal
67.
Input Terminal
⇒
67.
Direct Access Number — F119
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number — F120
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number — F121
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
H7 ASD Operation Manual
F121