Toshiba H7 Operation Manuals page 77

F130
OUT1 Output Terminal Assignment
Program Terminal Selection Parameters
⇒
Assignment ⇒ OUT1
This parameter sets the functionality of the OUT1 (A & C) output terminals to
1 of the 60 possible functions that are listed in
The on and off delay times of the OUT1 terminals may be adjusted to provide
more response time to the device that is connected to the output terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
OUT2 Output Terminal Assignment
Program ⇒ Terminal Selection Parameters
Assignment ⇒ OUT2
This parameter sets the functionality of the OUT2 (A & C) output terminals to
1 of the 60 possible functions that are listed in
The on and off delay times of the OUT2 terminals may be adjusted to provide
more response time to the device that is connected to the output terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
FL Output Terminal Assignment
Program Terminal Selection Parameters
⇒
Assignment ⇒ FL
This parameter sets the functionality of the FL output terminals to 1 of the 60
possible functions that are listed in
The on and off delay times of the FL terminals may be adjusted to provide
more response time to the device that is connected to the output terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
The FLA and FLC contacts are rated at
2A/250 VAC. The FLB contact is rated
at 1A/250 VAC.
Output #4 Terminal Assignment
Program ⇒ Terminal Selection Parameters
Assignment 4
⇒
This parameter sets the functionality of the output #4 terminals to 1 of the 60
possible functions that are listed in
The on and off delay times of the #4 terminals may be adjusted to provide more
response time to the device that is connected to the output terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
70
Output Terminal
⇒
Table 7 on pg. 72.
⇒ Output Terminal
Table 7 on pg. 72.
Output Terminal
⇒
Table 7 on pg. 72.
⇒ Output Terminal
Table 7 on pg. 72.
Direct Access Number — F130
Parameter Type — Selection List
Factory Default — Low
Changeable During Run — No
Direct Access Number — F131
Parameter Type — Selection List
Factory Default — RCH (A/D Complete)
Changeable During Run — No
Direct Access Number — F132
Parameter Type — Selection List
Factory Default — Fault
Changeable During Run — No
Direct Access Number — F133
Parameter Type — Selection List
Factory Default — LL
Changeable During Run — No
H7 ASD Operation Manual
F133