Toshiba H7 Operation Manuals page 113

F273
Jump Frequency #2 Bandwidth
Program Special Control Parameters
⇒
This parameter establishes a plus-or-minus value for Jump Frequency #2
(F272).
Jump Frequency #3
Program ⇒ Special Control Parameters
Same as Jump Frequency #1 (F270) and is used when multiple frequencies are
to be jumped (see the plus-or-minus value setting at F275). When multiple
jump frequencies overlap, the system will recognize the lowest and the highest
frequencies as one jump range.
Jump Frequency #3 Bandwidth
Program ⇒ Special Control Parameters
This parameter establishes a plus-or-minus value for Jump Frequency #3
(F274).
Jump Frequency Processing
Program Special Control Parameters
⇒
Frequency Processing
This parameter determines if the output frequency of the ASD or the PID
feedback signal will be used as a reference for determining the Jump
Frequency range.
See F270 for further information on the Jump Frequency settings.
Settings:
Process Amount (use PID feedback)
Output Frequency
106
Jump Frequencies
⇒
⇒ Jump Frequencies
⇒ Jump Frequencies
Jump Frequencies Jump
⇒ ⇒
Direct Access Number — F273
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 30.0
Units — Hz
Direct Access Number — F274
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F275
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 30.0
Units — Hz
Direct Access Number — F276
Parameter Type — Selection List
Factory Default — Process Amount
Changeable During Run — Yes
H7 ASD Operation Manual
F276