OIL SPECIFICATION NOT RESPECTED
General note
N N O O T T E E
An entry by the pilot in the engine log book of all pertinent details is required.
If by error engine was serviced with oil, which does not correspond with oil specification in
the Operators Manual and the engine has been in operation for less than 5 hours, the fol-
lowing measures must be taken:
Less than 5 hr.
Step
05–50–00
Page 26
December 01 2017
BRP-Rotax
MAINTENANCE MANUAL
Oil specification not respected
Procedure
1
Oil change.
2
Remove the lowest positioned banjo screw (1) (banjo bolt, plug screw or
screw socket) and drain the remaining oil from the crankcase. Screw in
banjo bolt or plug screw.
Tightening torque see Installation Manual 915 i A Series.
3
Replace oil filter.
4
Drain oil completely from oil cooler.
5
Drain oil from oil tank.
6
Refill oil tank with oil as specified, refer to Operators Manual.
7
Purge air from oil system.
See
Chapter 12-20-00 section Purging the oil system.
8
Run engine for approx. 1 hour and replace oil and oil filter once more, as
stated above.
Effectivity: 915 i A Series
Edition 0/Rev. 0