Rotax 915 i A SERIES Maintenance Manual page 35

Disassembly At disassembly of the engine, mark the components as necessary to avoid any mix-up.
Take care of these marks, don't ruin them.
Tool
In order to avoid mechanical damage, always loosen or tighten screws and nuts
Safety wiring
Cleaning of parts
Removed parts Before re-using disassembled parts, clean, check and refit them as per instructions.
Use clean screws and nuts. Always inspect the contact face and thread for damage. If un-
sure, use new parts.
Self-securing Once loosened, always replace self-securing nuts.
nuts
Exactly observe the tightening torques for screws and nuts. Overtightening or a connec-
Sealing rings, O- At reassembly of the engine, replace all sealing rings, gaskets, securing elements, O-rings
rings and oil seals.
Re-assembly Before re-assembly check components for missing parts. Only use adhesives, lubricants,
cleaning agents and solvents indicated in the maintenance instructions. Failure to comply
may result in damage.
Effectivity: 915 i A Series
Edition 0/Rev. 0
MAINTENANCE MANUAL
If during disassembling/reassembling the removal of a safety item (e.g. safety
wiring, self-locking fastener, etc.) should be necessary, it must always be re-
All metal and synthetic parts should be cleaned with suitable cleaning agents.
Before using new and unknown cleaning agents, check their compatibility with
the materials they are being used on.
Non-compliance can result in serious injuries or death!
tion which is too loose could cause serious engine damage.
BRP-Rotax
ATTENTION
with specified tools.
ATTENTION
placed by a new one.
ATTENTION
m WARNING
05–00–00
Page 5
December 01 2017