CHECKING THE COOLING SYSTEM
General note
Coolant hoses
Carry out visual inspection of all coolant hoses (1) for damage, leaks, hardening as a re-
sult of heat and porosity.
Water pump
Inspect all connections on the top and bottom of the cylinder head and on the water pump
(2).
Expansion tank
Inspect expansion tank (3) for damage. Inspect protection rubber at the bottom of the tank
for tight fit.
Radiator cap
Inspect the gasket of the radiator cap (4) and check the pressure release valve and return
valve for proper operation.
See
REPLACING THE COOLANT
General note
ENVIRONMENTAL NOTE
Do not harm the environment by spilling coolant. Dispose coolant in an environmentally
Instruction
To replace the coolant the following steps are necessary:
12–20–00
Page 18
December 01 2017
MAINTENANCE MANUAL
Risk of burns and scalds. Hot engine parts.
Always allow engine to cool down to ambient temperature before starting work.
Chapter 12-20-00 section Expansion tank, Radiator cap.
Never open the radiator cap when the cooling system is hot. For safety's sake, cover
cap with a rag and open slowly. Sudden opening of the cap could provoke the escape
of boiling coolant and result in scalding.
Use only coolant as recommended in the current Operators Manual
BRP-Rotax
m WARNING
m WARNING
Risk of Burns!
ATTENTION
Protect the environment!
friendly manner.
Effectivity: 915 i A Series
Edition 0/Rev. 0