Oil Specification Not Respected - Rotax 912 iSc Maintenance Manual

3.10) Oil specification not respected

NOTE:
General note
If by error engine was serviced with oil, which does not correspond with oil
specification in the Operators Manual and the engine has been in opera-
tion for less than 5 hours, the following measures must be taken:
less than 5 hr.
Step
1
2
3
4
5
6
7
8
Position of the plug screw
Graphic
Fig. 5
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
An entry by the pilot in the engine log book of all pertinent details
is required.
Oil specification not respected
Oil change.
Remove the lowest positioned banjo screw (1) (banjo bolt, plug screw or
screw socket) and drain the remaining oil from the crankcase. Screw in banjo
bolt or plug screw.
Tightening torque see Installation Manual 912 i Series.
Replace oil filter.
Drain oil completely from oil cooler.
Drain oil from oil tank.
Refill oil tank with oil as specified, refer to Operators Manual.
Purge air from oil system. See chapt. 12-20-00, section: 12.5).
Run engine for approx. 1 hour and replace oil and oil filter once more, as stat-
ed above.
Part
1 plug screw M22x1,5
2 plug screw M16x1,5
3 oil filter
Procedure
Function
05-50-00
page 18
January 01/2012