Rotax 915 i A SERIES Maintenance Manual page 66

When removing the propeller gearbox, take care not to damage the bearing point
and the oil seal running surface (on the roller bearing side) of the propeller shaft.
Figure 5.2
Step
Overload clutch, torsion shaft and propeller shaft are plugged only and can drop down.
05–50–00
Page 4
December 01 2017
BRP-Rotax
MAINTENANCE MANUAL
Hex./Torx-flange screw M8x45
1
Procedure
4
Install puller part no. 877660 onto the two threaded bolts M8 of the gear
cover.
5 The entire propeller gearbox can now be pulled off by moving the handle
of the special tool part no. 877660 without damaging the ball bearing or
propeller shaft.
Non-compliance can result in serious injuries or death!
ATTENTION
Sk/Torx-flange screw M6x40
2
m WARNING
Effectivity: 915 i A Series
Edition 0/Rev. 0