Rotax 915 i A SERIES Maintenance Manual page 86

0.5 bar
(50 kPa)
Figure 5.15: Overview and instruction
Oil pressure below minimum oil pressure on the ground
If noticed on ground, immediately stop the engine and determine the cause.
• Inspect the complete lubrication system, trace cause and rectify.
If the oil pressure falls below the minimum value up to max. 0.5 bar (7.25 psi) and for max.
1 min., the cause must be determined.
Table 5: Oil pressure below minimum permissible oil pressure up to max. 0.5 bar
Step
05–50–00
Page 24
December 01 2017
BRP-Rotax
MAINTENANCE MANUAL
Proceed as instructed
in table 5
Proceed as instructed
in table 6
0
Procedure
1 Inspect all oil lines for restrictions and clear passage.
2 Verify oil quantity.
3 Inspect pressure sensor.
4 Inspect indicating instrument to specifications of the manufacturer, replace
as required.
5 Inspect crankcase pressure (See Installation Manual, latest issue.).
6 If no cause for the low oil pressure is found after the above checks, carry
out an oil change.
Operating limit
(See Operators Manual 915 i Series)
1 min.
(7.25 psi) max. 1 min. in flight
Time
Effectivity: 915 i A Series
Edition 0/Rev. 0