Oil Pressure Below Minimum Value - Rotax 915 i A SERIES Maintenance Manual

Step
Exceeding over 160 °C (320 °F)
Step

OIL PRESSURE BELOW MINIMUM VALUE

General note
If the oil pressure falls below the minimum value, other limits are often exceeded,
N N O O T T E E
Any exceeding of the min. admissible oil pressure must be entered by the pilot in-
to the engine log book, stating duration extent of excessive pressure and pertinent
details.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL
Table 3: Excess temperature up to max. 160 °C (320 °F) max. 15 min.
Procedure
2 Inspect oil level in the oil tank.
3 Inspect oil cooler for contamination and check the entire oil circuit for cor-
rect functioning.
4 Check that oil lines are routed correctly and undamaged.
5 Cut oil filter housing and inspect filter mat for foreign matter.
6 Carry out oil change.
7 Inspect all further systems for correct functioning.
Table 4: Excess temperature over 160 °C (320 °F) for longer than 15 min.
Procedure
1 The whole oil system must be inspected, repaired or overhauled in accord-
ance with the BRP-Rotax instructions for continued airworthiness.
2
Inspect all further systems for correct functioning.
3 Carry out detailed inspection of the affected engine components.
4
The whole oil system (oil cooler, oil lines) must be inspected.
5
Cut oil filter housing and inspect filter mat for foreign matter.
6 Carry out oil change.
e.g. the oil temperature. Please observe the relevant instructions.
ATTENTION
05–50–00
Page 23
December 01 2017