Rotax 915 i A SERIES Maintenance Manual page 71

N N O O T T E E
Due to limited tolerances, it may be difficult to push the drive gear onto the end of
the crankshaft. If necessary, push it on in another position.
Step
Figure 5.7
Step
N N O O T T E E
If there is slight vertical run-out, replace the nut and repeat the measurement.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL
Procedure
2 Secure the Hex. nut M30x1,5 with LOCTITE 648 and screw it onto the
crankshaft along with the friction washer VS-30. Tightening torque 300
Nm (221 ft.lb.).
Crankshaft (power take off side)
1
3 Crankshaft
5 VS-30 friction washer
The sealing surface must be free from dirt and oil.
Procedure
3 Inspect the run-out. See also
(CS24)
Drive gear
2
4 Hex. nut
6 Serial number
ATTENTION
Chapter 72-10-00 section Wear limits.
05–50–00
Page 9
December 01 2017