Ext. Closed Loop - Danfoss ADAP-KOOL AKD 102 Operating Instructions Manual

6 How to Programme the Frequency Converter
3-13 Reference Site
Option:
6
[0] * Linked to Hand / Auto
[1] Remote
[2] Local
3-15 Reference 1 Source
Option:
[0] No function
[1] * Analog input 53
[2] Analog input 54
[7] Pulse input 29
[8] Pulse input 33
[20] Digital pot.meter
[21] Analog input X30/11
[22] Analog input X30/12
[23] Analog Input X42/1
[24] Analog Input X42/3
[25] Analog Input X42/5
[30]

Ext. Closed Loop 1

[31] Ext. Closed Loop 2
[32] Ext. Closed Loop 3
6-10 Terminal 53 Low Voltage
Range:
0.07 V* [0.00 - par. 6-11 V]
84
Function:
Select which reference site to activate.
Use local reference when in Hand mode; or remote reference when in Auto mode.
Use remote reference in both Hand mode and Auto mode.
Use local reference in both Hand mode and Auto mode.
NB!
When set to Local [2], the frequency converter will start with this setting again
following a 'power down'.
Function:
Select the reference input to be used for the first reference signal. par.3-15
Reference 2 Source
par.3-16 and par. 3-17
signals. The sum of these reference signals defines the actual reference.
This parameter cannot be adjusted while the motor is running.
Function:
Enter the low voltage value. This analog input scaling value should correspond to the low reference/
feedback value set in par.6-14 Terminal 53 Low Ref./Feedb. Value
MG.11.O1.02 - ADAP-KOOL ® is a registered Danfoss trademark
®
ADAP-KOOL Drive AKD 102 High Power
Reference 1 Source
Reference 3 Source
define up to three different reference
.
,