Danfoss ADAP-KOOL AKD 102 Operating Instructions Manual page 63

®
ADAP-KOOL Drive AKD 102 High Power
Data storage in LCP:
LCP Copy
1. Go to par. 0-50
2. Press the [OK] key
3. Select "All to LCP"
4. Press the [OK] key
All parameter settings are now stored in the GLCP indicated by the progress bar. When 100% is reached, press [OK].
The GLCP can now be connected to another frequency converter and the parameter settings copied to this frequency converter.
Data transfer from LCP to Frequency converter:
LCP Copy
1. Go to par. 0-50
2. Press the [OK] key
3. Select "All from LCP"
4. Press the [OK] key
The parameter settings stored in the GLCP are now transferred to the frequency converter indicated by the progress bar. When 100% is reached, press
[OK].
5.1.8 Initialisation to default settings
There are two ways to initialise the frequency converter to default: Recommended initialisation and manual initialisation.
Please be aware that they have different impact according to the below description.
Recommended initialisation (via par. 14-22
Operation Mode
1. Select par. 14-22
2. Press [OK]
3. Select "Initialisation" (for NLCP select "2")
4. Press [OK]
5. Remove power to unit and wait for display to turn off.
6. Reconnect power and the frequency converter is reset. Note
that first start-up takes a few more seconds
7. Press [Reset]
NB!
Parameters selected in par. 0-25
Operation Mode )
Par. 14-22
Par. 14-50
Par. 8-30
Par. 8-31
Par. 8-32
Par. 8-35
Par. 8-36
Par. 8-37
Par. 15-00
Par. 15-20
Par. 15-30
My Personal Menu
, will stay present, with default factory setting.
MG.11.O1.02 - ADAP-KOOL ® is a registered Danfoss trademark
5 How to Operate the Frequency Converter
Operation Mode initialises all except:
RFI Filter
Protocol
Address
Baud Rate
Minimum Response Delay
Max Response Delay
Maximum Inter-Char Delay
Operating Hours Over Volt's
to par. 15-05
Historic Log: Event Historic Log: Time
to par. 15-22
Alarm Log: Error Code
to par. 15-32
5
Alarm Log: Time
63