Danfoss ADAP-KOOL AKD 102 Operating Instructions Manual page 96

6 How to Programme the Frequency Converter
Illustration 6.11: Display example.
6.1.8 Changing a group of numeric data values
If the chosen parameter represents a numeric data value, change the
chosen data value by means of the [◄] and [►] navigation keys as well
▲ ▼
as the up/down [ ] [ ] navigation keys. Use the ◄] and [►] navigation
6
keys to move the cursor horizontally.
Use the up/down navigation keys to change the data value. The up key
enlarges the data value, and the down key reduces the data value. Place
the cursor on the value to be saved and press [OK].
6.1.9 Changing of data value, Step-by-Step
Certain parameters can be changed step by step or infinitely variably. This applies to par.1-20
Motor Frequency
1-23 .
The parameters are changed both as a group of numeric data values and as numeric data values infinitely variably.
6.1.10 Read-out and programming of indexed parameters
Parameters are indexed when placed in a rolling stack.
Alarm Log: Error Code
Par. 15-30
up/down navigation keys to scroll through the value log.
Preset Reference
Use par.3-10
Choose the parameter, press [OK], and use the up/down navigation keys keys to scroll through the indexed values. To change the parameter value,
select the indexed value and press [OK]. Change the value by using the up/down keys. Press [OK] to accept the new setting. Press [Cancel] to abort.
Press [Back] to leave the parameter.
96
Alarm Log: Time
to par. 15-32 contain a fault log which can be read out. Choose a parameter, press [OK], and use the
as another example:
MG.11.O1.02 - ADAP-KOOL
ADAP-KOOL
Illustration 6.12: Display example.
Illustration 6.13: Display example.
Motor Power [kW]
, par.1-22
® is a registered Danfoss trademark
®
Drive AKD 102 High Power
Motor Voltage
and par.