Run Vds-Id Test; View And Save The Sheet Data - Keithley 4200-SCS User Manual

Section 1: Getting Started
Figure 1-36
Setup for SMU3
If you make any changes to
the SMU3 setup, click
enter the changes and close
the window.
3. After making any changes to the test definition, click Save All
the settings.

Run vds-id test

In the project navigator (see
checkbox is checked.
On the toolbar, click the green Run Test
NOTE

View and save the sheet data

View data sheet for the vds-id test is displayed by clicking the Sheet tab for the test. Use the tabs
at the bottom of the Sheet to display the data type. A sample data sheet for the vds-id test is
shown in
The data sheet for the vds-id test is displayed by clicking the Sheet tab.
1-42
Click to set up
Click to set up
Click to set up
OK to
Figure
While the test is running, the Run Test button turns gray and the Abort Test button
turns red . Also, the ACTIVE indicator light (located on the lower right-hand
corner of the front panel of the 4200-SCS will be on while the test is running. When
the test is finished, the Run test button turns green.
Figure 1-37.
Return to
1-34), make sure the vds-id test is highlighted and the
button to run the test one time.
Section Topics
Model 4200-SCS User's Manual
These parameters set
the gate voltage steps:
Click to set up
2V, 3V, 4V, and 5V.
on the toolbar to save
4200-900-01 Rev. K / February 2017