Modifying The Cvsweep Utm; Executing The Test - Keithley 4200-SCS User Manual

Model 4200-SCS User Manual

Modifying the cvsweep UTM

The default cvsweep parameters will sweep the voltage from -4 V to +6 V. If these parameters are
acceptable, proceed to
To modify the parameters:
1.
Figure 4-70
cvsweep UTM
2.
NOTE

Executing the test

Since this new project has only one subsite plan and only one device plan, the test can be run from
any level in the project navigator. To run the cvsweep test, click the green Run button. After the
test is finished, use the sheet and graph tabs to view and analyze the results.
NOTE
4200-900-01 Rev. K / February 2017
Executing the test on page
In the project navigator, double-click the cvsweep UTM to open it. The window in
Figure 4-70 will be displayed:
Click the Definition tab and make the desired parameter changes to the test.
For details about the cvsweep UTM, refer to the
cvsweep UTM, page
The 4200-SCS also supports the Keithley Instruments Model 595 Quasistatic C-V Meter
and the Keithley Instruments Model 82-WIN Simultaneous C-V System.
For more information, refer to the
Connections tab, page 7-25
System, page E-1.
Return to
Section 4: How to Control Other Instruments with the Model 4200-SCS
4-43.
C-11.
Reference Manual, KI595 CV Analyzer Properties and
and Reference Manual, Using a Keithley Model 82 C-V
Section Topics
Reference Manual, Open and execute
4-43