Performing A Ping Test - JDS Uniphase HST-3000 User Manual

2 Press the Results soft key to clear the results or save
3 Press the Display soft key to view different types of statis-
Testing line quality is complete.
Performing a
The ping test sends a ping packet through the modem to an
IP address or DNS name (could be a network switch or web
ping test
address) to test for connectivity.
The ping feature is available when the data mode is set to IP
over Ethernet (IPoE)
The following procedure describes how to perform a ping test.
To perform a ping test
1 Locate the Actions soft key.
HST-3000 VDSL Testing User's Guide
them to a text file.
For more information on saving results and managing the
files, see the HST-3000 Base Unit User's Guide.
tics.
See "Data mode results" on page 75
interpreting the results.
NOTE:
You can also check connectivity using the web browser.
See "Web browser" in the base manual for more informa-
tion.
If you do not see the Actions soft key, do the following:
a Check the Data LED.
The Data LED must be green in order to use the
Actions softkey. If the Data LED is red, the network
connection is not properly established.
b Press the Configure navigation key and make sure all
settings are correct for the circuit.
c Press the Home navigation key.
Chapter 2 VDSL Testing
Testing Data services
for information on
51