Performing A Ping Test - JDS Uniphase HST-3000 User Manual

Chapter 3 Data testing

Performing a ping test

Performing a ping test

48
Testing line quality is complete.
The ping test sends a ping packet through the modem to an
IP address or DNS name (could be a network switch or web
address) to test for connectivity.
NOTE:
You can also check connectivity using the web browser.
See "Web browser" in the base manual for more informa-
tion.
The ping feature is available when the data mode is set to IP
over Ethernet (IPoE)
The following procedure describes how to perform a ping test.
To perform a ping test
1 Locate the Actions soft key.
If you do not see the Actions soft key, do the following:
a Check the Data LED.
The Data LED must be green in order to use the
Actions softkey. If the Data LED is red, the network
connection is not properly established.
b Press the Configure navigation key and make sure all
settings are correct for the circuit.
c Press the Home navigation key.
d Press the Display soft key, and then select Data - IP.
See if there are any error messages.
e Locate the Actions soft key.
2 Press the Actions soft key.
HST-3000 xDSL Testing User's Guide