Select And Navigate A Saved Itrack - Humminbird i-Pilot Link Operation Manual

Select and Navigate a Saved iTrack

If a saved iTrack is within 1/4 mile of the boat position, you can start navigation towards it. iTrack navigation will start towards the
nearest point on the iTrack, and then it will navigate to the Start Point or End Point, depending on your selection.
NOTE: If you start another mode of i-Pilot Link navigation, Navigate iTrack will disengage automatically. The exception is
Spot-Lock, which if this is engaged, iTrack navigation will be paused, not disengaged. See Spot-Locks: Resume i-Pilot Link
Navigation (Spot-Lock Pause) for more details.
Select and Navigate a Saved iTrack in the Chart View
Touch Screen
1. Press and hold a position on the iTrack.
2. Tap Chart in the status bar. Select Go To.
OR
Select the Go To button on the X-Press Remote.
3. From the menu, select one of the following options:
To navigate to the iTrack Start Point, select Go To
Start.
To navigate to the iTrack End Point, select Go To End.
4. To start navigation, turn on the i-Pilot Link prop.
Cancel Navigation: Tap Chart in the status bar. Select
Go To > Cancel Navigation.
NOTE: See Propeller Controls for more details about turning the prop on or off and setting the prop speed.
iTracks
Keypad
1. Use the Joystick to move the cursor to a position on
the iTrack.
2. Press the GO TO key.
3. From the menu, select one of the following options:
To navigate to the iTrack Start Point, select Go To
Start.
To navigate to the iTrack End Point, select Go To End.
4. To start navigation, turn on the i-Pilot Link prop.
Cancel Navigation: Press the GO TO key. Select Cancel
Navigation.
92