Adjust The Contour Offset During Navigation; Reverse Direction - Humminbird i-Pilot Link Operation Manual

Adjust the Contour Offset During Navigation

The Contour Offset can be adjusted while Follow the Contour navigation is in progress.
Touch Screen
1. Tap Chart in the status bar. Select Go To.
2. Select Follow the Contour.
3. Select Contour Offset. Drag the slider, or press and
hold the slider, to adjust the setting.
To remove the offset, set the offset to 0 (off).
WARNING! Contour Offset does NOT account for changes in water depth. It is important to be aware of depth variations in your
current location and selected navigation route, and adjust the Contour Offset as needed.

Reverse Direction

If you are following vegetation or bottom hardness, you can quickly change the navigation direction by selecting Reverse.
Touch Screen
1. Tap Chart in the status bar. Select Go To.
2. Select Reverse.
CAUTION! Be prepared for boat movement as the prop will automatically be enabled and the prop speed will automatically adjust
to move the boat per the command. If the boat does not move, confirm the prop is turned on in the menu system (see
Propeller Controls).
Keypad
1. Press the GO TO key.
2. From the Go To menu, select Follow the Contour.
3. Select Contour Offset. Turn the Rotary dial, or press
and hold the ENTER key, to adjust the setting.
To remove the offset, set the offset to 0 (off).
Keypad
1. Press the GO TO key.
2. Select Reverse.
3. Press the ENTER key.
111 Follow the Contour