Deploy The Motor; Pause Deploying Or Stowing; Adjust The Trim; Prop On/Off - Humminbird i-Pilot Link Operation Manual

Deploy the Motor

The first time you deploy the motor (after installation or after defaults have been reset), you will adjust the trim for operation. The
control head will save the most-recent trim setting and apply it when the motor is deployed again.
WARNING! As soon as Deploy is selected, the motor will deploy automatically. Before you deploy or stow the motor, confirm the
motor is clear from obstructions and has a clear path of travel. The propeller is disabled while the motor is being trimmed to
prevent accidental contact with the rotating propeller.
Touch Screen
1. Open the Ulterra dialog box.
2. Tap the Deploy button.
Trim Adjust (Installation only): Tap the Trim up or
down arrows.
Pause: Tap the Pause button.

Pause Deploying or Stowing

Use the following instructions to pause the trolling motor while it is being deployed or stowed.
Touch Screen
1. Open the Ulterra dialog box.
2. Tap the Pause button.
To resume deploying, see Deploy the Motor.
To resume stowing, see Stow the Motor.

Adjust the Trim

Use the following instructions to adjust the trim. The Trim menu is available when the motor is deployed. The control head will save
the most recent trim setting and apply it when the motor is deployed again, even after power off.
Touch Screen
1. Open the Ulterra dialog box.
2. Tap the Trim up or down arrows.

Prop on/off

Use the following instructions to turn on the prop from the Ulterra dialog box.
Touch Screen
1. Open the Ulterra dialog box.
2. Tap the Propeller button to turn it on/off.
Ulterra
Keypad
1. Open the Ulterra dialog box.
2. Select the Deploy button. Press the ENTER key.
Trim Adjust (Installation only): Select a Trim up or
down arrow. Press the ENTER key to move the motor in
the selected direction.
Pause: Select the Pause button.
Keypad
1. Open the Ulterra dialog box.
2. Select the Pause button. Press the ENTER key.
To resume deploying, see Deploy the Motor.
To resume stowing, see Stow the Motor.
Keypad
1. Open the Ulterra dialog box.
2. Select a Trim up or down arrow. Press the ENTER key to
move the motor in the selected direction.
Keypad
1. Open the Ulterra dialog box.
2. Select a Trim up or down arrow. Press the ENTER key to
move the motor in the selected direction.
34