Start Circle Mode At The Cursor Position; Adjust Circle Mode Settings - Humminbird i-Pilot Link Operation Manual

Start Circle Mode at the Cursor Position

Use the following instructions to start Circle Mode at the cursor position using the Go To menu. The boat must be within 1/4 mile
of the cursor position to begin Circle Mode navigation. Starting Circle Mode at the cursor position is not available on the X-Press
Remote.
CAUTION! Be prepared for boat movement as the prop will automatically be enabled and the prop speed will automatically adjust
to move the boat when Circle Mode is engaged. If the boat does not move, confirm the prop is turned on in the menu system (see
Propeller Controls).
Touch Screen
1. Tap a position on the chart.
2. Tap Chart in the status bar.
3. Select Go To.
4. Select Circle.
5. Select Circle > At Cursor.
Adjust the Radius (optional): Select Radius. Drag the
slider, or press and hold the slider.
6. Select Clockwise or Counterclockwise.
Cancel Navigation: Tap Chart in the status bar. Select
Go To > Cancel Navigation.

Adjust Circle Mode Settings

CAUTION! Be prepared for boat movement as the prop will automatically be enabled and the prop speed will automatically adjust
to move the boat when Circle Mode is engaged. If the boat does not move, confirm the prop is turned on in the menu system (see
Propeller Controls).
Reverse Direction during Circle Mode
Touch Screen
1. Tap Chart in the status bar.
2. Select Go To.
3. Select Reverse.
Adjust the Radius during Circle Mode
Use the following instructions to adjust the size of the circle.
Touch Screen
1. Tap Chart in the status bar.
2. Select Go To.
3. Adjust: Select Radius. Drag the slider, or press and hold
the slider.
Keypad
1. Use the Joystick to select a position on the chart.
2. Press the GO TO key.
3. Select Circle. Press the ENTER key.
4. Select Circle > At Cursor.
Adjust the Radius (optional): Select Radius. Turn the
Rotary dial, or press and hold the ENTER key.
5. Select Clockwise or Counterclockwise. Press the
ENTER key.
Cancel Navigation: Press the GO TO key. Select Cancel
Navigation. Press the ENTER key.
Keypad
1. Press the GO TO key.
2. Select Reverse. Press the ENTER key.
Keypad
1. Press the GO TO key.
2. Select Radius.
3. Adjust: Turn the Rotary dial, or press and hold the
ENTER key.
83 Circle Mode