Create A Saved Route - Humminbird i-Pilot Link Operation Manual

Create a Saved Route

The instructions in this section allow you to create a route in the Chart View and save it for navigation later. The steps are similar to
creating a Quick Route, but you use the Mark menu to start.
• Save Location: The route is saved to the Nav Data tool.
• Navigation: To start navigation on the route, see Navigate a Saved Route.
• Overlay: To display saved routes on the Chart View, press the MENU key once. Select Chart Options > Overlays > Nav Data >
Routes (Saved).
Create a Saved Route
Touch Screen
1. Tap Chart in the status bar. Select Mark.
2. Select Route.
3. Tap the screen in the positions where you want to
mark a route point.
Undo Last Route Point: Tap the Back icon.
Cancel Route Creation: Tap the X icon.
4. To save the route, tap the Check icon in the status bar.
NOTE: If the position you select is also a Contour Line, a submenu will open with related menu options. To add the position to the
route, select Go To Position.
Routes
Keypad
1. Press the MARK key.
2. Select Route.
3. Use the Joystick to move the cursor to a position or
waypoint. Press the Joystick to mark the first route
point.
4. Repeat Step 3 to connect more than one route point.
Undo Last Route Point: Press the EXIT key once.
Cancel Route Creation: Press and hold the EXIT key.
Select Discard, and press the ENTER key.
5. To save the route, press the ENTER key.
114