Start Autopilot Based On The Motor's Heading - Humminbird i-Pilot Link Operation Manual

Start AutoPilot Based on the Motor's Heading

When you start AutoPilot navigation without an active cursor, the heading will be based on the trolling motor's heading. AutoPilot
continues to navigate the boat in the same direction.
CAUTION! Be prepared for boat movement as the prop will automatically be enabled and the prop speed will automatically adjust
to move the boat into position. If the boat does not move, confirm the prop is turned on in the menu system (see Propeller
Controls).
NOTE: After steering to a new direction, there is a short delay before the direction is locked in to allow the compass to stabilize.
When broad speed changes are made, the motor heading may change slightly. This is normal.
Start AutoPilot Based on the Motor's Heading (Go To Menu)
Touch Screen
1. Confirm the cursor is not active.
2. Tap Chart in the status bar.
3. Select Go To.
4. Select AutoPilot.
5. To start navigation, turn on the i-Pilot Link prop.
Cancel Navigation: Tap Chart in the status bar. Select
Go To > Cancel Navigation. Then, turn off the i-Pilot Link
prop.
NOTE: See Propeller Controls for more details about turning the prop on or off and setting the prop speed.
Start AutoPilot Based on the Motor's Heading (X-Press Remote)
Touch Screen
1. Open the X-Press Remote: Tap the top, right corner of
the status bar. Tap the remote.
2. Tap the Auto Pilot button.
3. To start navigation, turn on the i-Pilot Link prop.
Adjust Heading: Tap the RIGHT or LEFT arrow buttons.
Cancel Navigation: Tap the Auto Pilot button. Then,
turn off the i-Pilot Link prop.
AutoPilot
Keypad
1. Confirm the cursor is not active.
2. Press the GO TO key.
3. Select AutoPilot. Press the ENTER key.
4. To start navigation, turn on the i-Pilot Link prop.
Cancel Navigation: Press the GO TO key. Select Cancel
Navigation. Then, turn off the i-Pilot Link prop.
Keypad
1. Open the X-Press Remote: Press the POWER key.
Select the remote.
2. Select the Auto Pilot button. Press the CHECK/ENTER
key.
3. To start navigation, turn on the i-Pilot Link prop.
Adjust Heading: Use the Joystick to select the RIGHT or
LEFT arrow button. Press the ENTER key.
Cancel Navigation: Select the Auto Pilot button. Press
the ENTER key. Then, turn off the i-Pilot Link prop.
124