Set The Autopilot Mode - Humminbird i-Pilot Link Operation Manual

Confirm i-Pilot Link Navigation is Enabled
Use the following instructions to confirm i-Pilot Link Navigation is enabled. The AutoPilot must be set up correctly with the
Humminbird control head when it is first installed, refer to your control head operations manual for more information.
NOTE: See Configure i-Pilot with the Control Head: Enable i-Pilot Link Navigation for more details.
1. Press the HOME key.
2. Select Settings.
3. Under Settings, select Navigation > i-Pilot Navigation.
4. Tap the on/off button, or press the ENTER key, to turn it on.

Set the AutoPilot Mode

1. Press the HOME key.
2. Select Settings > Navigation.
3. Under i-Pilot Options, select i-Pilot AutoPilot.
4. Tap, or press the ENTER key, to open the i-Pilot AutoPilot submenu.
5. Select Legacy or Advanced.
When Legacy AutoPilot Mode is selected, the blue icon is displayed in the i-Pilot Link data bar on the Chart View.
When Advanced AutoPilot Mode is selected, the yellow icon is displayed in the i-Pilot Link data bar on the Chart
View.
NOTE: For more information about the i-Pilot Link data bar, see Display Digital Readout Boxes.
121 AutoPilot